+371 66 77 88 20
b2b@elektrika.lv 
Spacelogic KNX USB Interface DIN Rail. For connecting a programming or diagnostics device with a USB 2.0 interface to the KNX. The USB connector (Type C) is galvanic isolated from the KNX bus. It can be used as a programming interface for ETS Software Version 4 (or higher). The device is programmed locally with the physical address and does not have a programming button and programming LED. With 2 status LEDs. The KNX USB interface supports KNX “longframe” communication and is compatible with KNX security telegrams/devices. This allows faster KNX downloads if supported by the target device (e.g. MTN6725-0001). For installation on DIN rails TH35 according to EN 60715. The bus is connected using a bus connecting terminal. Device width - 1 module = approx. 18 mm. Contents - With bus connecting terminal and cable cover.
Cables and wires 
Installation 
Automatics and control 
Lighting 
Renewable energy 
Tools 
Power tools and accessories 
Industrial products 
Lightning protection 
Insulating materials and chemistry 
Heating and ventilation 
Computers and Telecommunications 
Work wear and accessories 
Consumer electronics 
Smart Home 
For garden, leisure and tourism 
